More RouterOSv7 routing filter examples are here. Multiple rules without action are stacked in a single rule and executed in order like a firewall, the reason is that the "set" parameter order is important and writing one "set"s per line, allows for an easier understanding from top to bottom on what actions were applied. then" syntax to set parameters or apply actions based on conditions from the "if" statement. The routing filter configuration is changed to a script-like configuration.
Upgrade MPLS setups with caution, and make sure to backup configuration before the upgrade.Īll supported options are upgraded without any issue, in the case of an unsupported option - an empty entry is created. OSPF menus interface and neighbor contains read-only entries for status monitoring. RouterOSv7 uses templates to match the interface against the template and apply configuration from the matched template. To start OSPF you need to create an instance and then add are to the instance. At the moment there are no default instances and areas. OSPFv2 and OSPFv3 are now merged into one single menu /routing ospf. Networks are added to the firewall address-list and referenced in the BGP connection configuration.Īll known configurations will upgrade from 6.x to 7.x successfully. Other great debugging information on all routing processes can be monitored from /routing stats menu. Now you can monitor the status of all connected and disconnected peers from /routing bgp session menu. Peer role is now a mandatory parameter, for basic setups, you can just use ibgp, ebgp. It is possible that in setups where peer uses the multi-hop connection local.address must be configured too. Most of the parameters are similar to the previous implementation except that some are grouped in the output and input section making the config more readable and easier to understand whether the option is applied on input or output.īGP connection minimal set of parameters are remote.address, template, connect, listen and local.role Connect and listen to parameters specify whether peers will try to connect and listen to a remote address or just connect or just listen. It can be used as a template for dynamic peers and apply a similar config to a group of peers. Template contains all BGP protocol-related configuration options. v7 BGP implementation provides with connection, templateand session menus.
But keep in mind that there is a complete redesign of the configuration. To re-trigger v6 configuration conversion, load ROSv6 backup with the option force-v6-to-v7-configuration-upgrade=yes.Īll known configurations will upgrade from 6.x to 7.x successfully. This means that if a router was downgraded to ROSv6, the configuration was modified and the router got upgraded back to ROSv7, then the resulting configuration is the one that was present before the downgrade. The routing protocol configuration upgrade is triggered only once.
0 kommentar(er)
